One of the biggest improvements you can make to a tiny camera is a better way to hold it -- and that's what Richard has done for the Olympus XZ-1.
Install Instructions
Please review these mounting instructions carefully before attaching the grip to the camera to avoid problems associated with improper mounting.
Once it's on, you'll enjoy the better, more secure feeling when handling your XZ-1, even one handed.
To mount the grip to the camera, please follow the steps below:
1. Dry Run - perform the "dry run" below so you understand the position the grip should be in for final mounting:
- Leave the backing material on the VHB clear transfer tape - do not remove.
- Take the battery out of the camera and close the battery door.
- Place the grip on the camera
- Slide the grip toward the lens until the curved lip of the grip comes in contact with the side of the camera.
- Slide the grip up and down until it is positioned slightly below the Olympus logo and at the top of the bevelled edge on the bottom of the front plate.
- This is the reference position for proper placement of the grip.
- Repeat this step until you know the right position.
- Properly mounted grip::
2. Use rubbing alcohol (not included) to remove any impurities and skin oils from the mounting surface area on the camera. Wipe dry.
3. Peel the backing material from the tape. Don't touch the sticky side with your fingers.
4. Hold the grip just above the correct position without touching the camera. You will not be able to freely slide the grip once it makes contact with the camera - so be sure it's just above where you want it. Then gently put it in place.
Don't apply pressure at this time. You can't slide the grip, but you can make minor adjustments and you can pull it off the camera to reposition it. Take your time and do it right. Make sure the curved lip of grip is against the side of XZ-1 over the entire length and the grip is not cocked.
5. Once you're satisfied with the placement, press the grip down and from the side firmly.
6. You're grip is now attached. For best results, press the grip from several different spots to ensure a uniform bond. Always press straight down toward the camera body.
After affixing the grip, let it sit for about 30 minutes before handling it. The full-strength bond takes effect within several hours.
Note: The adhesive used for mounting the grip has exceptional holding power when the grip is mounted properly on the camera. Regardless of that, the use of a wrist or neck strap is highly recommended to ensure complete safety.
The grip can be removed if really needed by using dental floss between the grip and camera body to cut the adhesive. Use caution doing so.
